The kit Minipuls 4 was developed for the generation of sinusoidal voltages in the range 5-20 kHz and amplitudes up to 20 kV peak (corresponding to 40kVpp or 14kV RMS). The kit consists of two boards: the full bridge board which is completely low voltage and the high voltage transformer cascade board. Power supply can be achieved with a standard laboratory power supply. Control is by external signal.

Full bridge board:

• Supply voltage 15-40 V

• Maximum input power <320W

• max. average output power 300W, peak power may be higher for a limited amount of time.

• peak current limit 40A.

• overtemperature shutdown

• Power supply fuse 10A.

• Nominal pulse frequency 10 kHz; recommended frequency range 5-20 kHz; possible frequency range 0-50 kHz.

• Waveform: The full bridge delivers square wave signal with either positive voltage, negative voltage, or a 0V pause, depending on input control signal.

• Size 127*178mm, weight 0.37kg

Full bridge board:

• Supply voltage 15-40 V

• Maximum input power <320W

• max. average output power 300W, peak power may be higher for a limited amount of time.

• peak current limit 40A.

• overtemperature shutdown

• Power supply fuse 10A.

• Nominal pulse frequency 10 kHz; recommended frequency range 5-20 kHz; possible frequency range 0-50 kHz.

• Waveform: The full bridge delivers square wave signal with either positive voltage, negative voltage, or a 0V pause, depending on input control signal.

• Size 127*178mm, weight 0.37kg